Dynamic Nodes generation and traffic flow in ns2

Here is the code for dynamically creating nodes and create traffic flow dynamically using protocol.


#Create a simulator object
set ns [new Simulator]

#Tell the simulator to use dynamic routing
$ns rtproto DV

#Open the nam trace file
set nf [open out.nam w]
$ns namtrace-all $nf


#Define a 'finish' procedure
proc finish {} {
        global ns nf
        $ns flush-trace
#Close the trace file
        close $nf
#Execute nam on the trace file
        exec nam out.nam &
        exit 0
}

#Create seven nodes
for {set i 0} {$i < 7} {incr i} {
        set n($i) [$ns node]
}


#Create links between the nodes
for {set i 0} {$i < 7} {incr i} {
        $ns duplex-link $n($i) $n([expr ($i+1)%7]) 1Mb 10ms DropTail
}

#Create a UDP agent and attach it to node n(0)
set udp0 [new Agent/UDP]
$ns attach-agent $n(0) $udp0

# Create a CBR traffic source and attach it to udp0
set cbr0 [new Application/Traffic/CBR]
$cbr0 set packetSize_ 500
$cbr0 set interval_ 0.005
$cbr0 attach-agent $udp0


#Create a Null agent (a traffic sink) and attach it to node n(3)
set null0 [new Agent/Null]
$ns attach-agent $n(3) $null0

#Connect the traffic source with the traffic sink
$ns connect $udp0 $null0

#Schedule events for the CBR agent and the network dynamics
$ns at 0.5 "$cbr0 start"
$ns rtmodel-at 1.0 down $n(1) $n(2)
$ns rtmodel-at 2.0 up $n(1) $n(2)
$ns at 4.5 "$cbr0 stop"
#Call the finish procedure after 5 seconds of simulation time
$ns at 5.0 "finish"

#Run the simulation
$ns run

So, here is the output sequence. 

First, nodes are created 

Then, down the links and see how dynamically traffic flow by following the other path 

Then , here is the final output .